Atomic Filament Carbon Fiber PLA

Atomic Filament Carbon Fiber PLA is a PLA filament rated to a 120°C heat deflection temperature. This page collects its hardware, environmental, and handling requirements in one place so you can confirm your printer is up to the job before you load the spool.

Material Overview

Atomic Filament Carbon Fiber PLA is an engineering-grade 3D printing filament built on a PLA polymer base. With a heat deflection temperature of 120°C, it is engineered for functional parts that must hold their shape under load and elevated service temperatures — jigs, fixtures, brackets, ducting, and end-use components that would deform in a commodity material.

Selecting Atomic Filament Carbon Fiber PLA is a systems decision, not just a spool decision: the polymer base dictates your hotend, your chamber, and your drying workflow. The sections below translate the manufacturer’s data into the concrete hardware and environmental requirements your printer must satisfy.

At a glance

• Polymer base: PLA
• Heat deflection temperature: 120°C
• Nozzle requirement: Hardened Steel Required
• Enclosure requirement: Open Air OK

Hardware & Environmental Requirements

The table below summarizes the hardware and environmental prerequisites for printing Atomic Filament Carbon Fiber PLA. Always confirm final values against the manufacturer’s official technical data sheet.

Nozzle & Hotend

Atomic Filament Carbon Fiber PLA is an abrasive, fibre-reinforced filament. The carbon or glass fillers will rapidly erode a soft nozzle, so a hardened steel hotend (or a carbide/tool-steel alternative) is mandatory. Expect noticeably higher extrusion torque as well, so confirm your extruder can sustain the flow before running long prints. CSV designation: Hardened Steel Required.

Enclosure & Chamber

Atomic Filament Carbon Fiber PLA prints comfortably in the open air. No enclosure is required, though keeping the printer away from strong drafts or air-conditioning vents will still improve first-layer consistency and reduce edge lifting.

Frequently Asked Questions

Can I print Atomic Filament Carbon Fiber PLA with a standard brass nozzle?

No. Atomic Filament Carbon Fiber PLA is abrasive and will destroy a brass nozzle in short order. You must use a hardened steel (or carbide) nozzle — a tool-steel upgrade protects the hotend and keeps extrusion consistent over the life of the spool.

Does Atomic Filament Carbon Fiber PLA require an enclosure?

Atomic Filament Carbon Fiber PLA prints comfortably in the open air. No enclosure is required, though keeping the printer away from strong drafts or air-conditioning vents will still improve first-layer consistency and reduce edge lifting.

Does Atomic Filament Carbon Fiber PLA need to be dried before printing?

Store Atomic Filament Carbon Fiber PLA sealed with desiccant and dry the spool before any critical print. As a rule of thumb, dry at 60-80 °C for 4 hours and print from a dry environment to protect layer strength and surface finish.